Glider Project Deployed Recovered Days Distance Start/
End Voltage
Air Time POC Notes Payload KMZs Data Metadata
ru28-551 NJDEP/EPA 2018-09-20
13:34 GMT
2018-10-09
17:52 GMT
19.18 354.5
km
15.44 Volts
12.14 Volts
2336
minutes
Haldeman
Waite
Aragon
15 ? kmzs

deployment Notes (15)  

Select Category: Deployment Glider All

Posted/
Updated
Category
2019-01-14 20:01 GMT
dkaragon
deployment Optode SN 971 had some noise in readings found by Laura P. Chip and Dave checked optode in lab 1/14/2019 and found the foil was *slightly shifted and could see green light behind one side of the shifted foil. Applying pressure to the foil caused the numbers to fluctuate to a rough maximum of +- 10 micro moles. Usually < +- 5 micro moles. Optode should go back for check up and possibly new foil before being used again. Optode 3835 rated to 300 m
2018-10-27 02:11 GMT
dkaragon
deployment CC is off
2018-10-23 18:09 GMT
waite
configuration SVS serial number is 121
2018-10-10 01:52 GMT
waite
deployment Schuyler reported a red tide going on in the water at recovery
2018-10-09 18:34 GMT
waite
deployment Recovered off Atlantic City by Schuyler Nardelli and the NJ DEP.

CTD cast with SBE19 s/n 1383, and a shall_nw.mi mission (log file 03970000)
2018-10-07 22:41 GMT
dkaragon
deployment CC is off
2018-10-07 11:48 GMT
dkaragon
deployment Beh aborts: think science crashing and not coming up in time to open log files.
2018-10-02 15:06 GMT
dkaragon
deployment Longer deployment here will be better for weather and travel, optics to every other yo, see if that helps. LISST to every 16th yo
2018-10-01 15:25 GMT
dkaragon
deployment Spent last night near Orsted buoy F230 with wave sensor ON, moving onward today

2018-09-25 23:21 GMT
dkaragon
deployment Make that every 6th
2018-09-25 23:19 GMT
dkaragon
deployment Lisst every 4th yo, wave off after storm.
2018-09-21 01:27 GMT
dkaragon
deployment Wave SVS on overnight
2018-09-20 19:11 GMT
dkaragon
deployment ru28.mi:

# ru28 Custom Config
# 8/14/2014 initial based on 2014 NJDEP 1
# 8/15/2015 disabled the filter; I don't think it does anything useful
# 2018/9/20 added lengthened abort timers


# Low density abort stuff
sensor: u_abort_min_burn_time(sec) 600 # Never drop the weight before this time
sensor: u_abort_max_burn_time(sec) 28800 # 8 hrs, at least a tidal cycle, Always drop the weight after this time

# ALTIMETER
sensor: u_alt_reduced_usage_mode(bool) 0
sensor: u_alt_reqd_good_in_a_row(nodim) 1
sensor: u_alt_filter_enabled(bool) 0

sensor: u_min_altimeter(m) 2.0
sensor: u_max_altimeter(m) 8.5

sensor: u_alt_min_depth(m) 1

# Avoid old bug
sensor: m_altitude_rate(m/s) -1


# STEERING
sensor: u_hd_fin_ap_gain(1/rad) 1.50
sensor: u_hd_fin_ap_igain(1/rad-sec) 0.01
sensor: u_hd_fin_ap_dgain(sec/rad) 5.00

sensor: u_heading_deadband(rad) 0.087
sensor: u_heading_rate_deadband(rad/s) 0.0087

sensor: u_hd_fin_ap_deadband_reset(bool) 0 # true - reset integrator, false hold integrator
sensor: u_hd_fin_ap_hardover_holdoff(sec) 60.0

2018-09-20 19:11 GMT
dkaragon
deployment Deployed out of Shark River by DEP Rand Haldeman Waite and Evan Ramsay. Deployed 3 miles due east of inlet due to weather.
2017-10-19 17:46 GMT
dkaragon
configuration GPCTD 103P
FLBBCD 2797
OPTODE 3835 SN 971 (previous optode cable failed, noticed in lab)
LISST-200X SN 7003 FIRMWARE 1.415
SVS603 SN and firmware to be checked!
VMT SN 1144951